Create Configuration

Create a netcfg.txt config file (and possibly a wpa_supplicant.conf too) for your pi image

Step 1. Enter Network config

Put in the desired static IP address/mask and default gateway. Then click "Generate"

If you have a pi with wifi (pi zeroW, pi 3+ or pi 4) you can set the intrerface type to wifi and then set an SSID and PSK secret.

Note: the pi will only use one interface (eth0 or wlan0) for the first boot. DNS server IPs should be split by spaces

Ethernet or Wifi
IP address/mask (e.g. 192.168.1.21/24) Not validated
Default Gateway (e.g. 192.168.1.1) Not validated
DNS Server (e.g. 192.168.1.53 9.9.9.9) Not validated

Step 2. Save Config Files

The netcfg.txt config file to be downloaded will be generated here:

Save to netcfg.txt on the /boot partition of the SD card you just installed the pi firmware on

© 2020 Francis Turner